CX2310 output selection

  1. #1 by Mark Sander on 4 Weeks Ago
    Mark Sander's Avatar
    Posts: 1

    CX2310 output selection

    Hi All, I am sure this has been asked before but I can't find a simple answer on the forum. I want to run the CX2310 crossover in two channel stereo mode and want to connect the dedicated sub out on the crossover to a 15" powered sub with a range of 35Hz to 125Hz. I also have two full range cabinets with 15' speakers and compression drivers and a range of 45-20KHz.
    I will come out of the crossover and into the two channels of the amp then out to the full range speakers.

    My question is when the CX2310 is in two way stereo mode i assume i use the high outputs to run to the amp. And where should i set the crossover frequency considering the range of my combo speakers. Any other advice most welcome as I am very new to this.