Voicelive 3 monitor input not working

  1. #1 by Enrico Sau on 2 Weeks Ago
    Enrico Sau's Avatar
    Posts: 41

    Voicelive 3 monitor input not working

    Hi,
    I'm using a voicelive 3, I can't manage to have the monitor input signal in headphones.
    Everything else in headphones is ok, monitor should be working because The signal goes fine to monitor out and to other equipment.
    I'm able to open the headphones mix tab but even if I put monitor in to the maximum level, I got nothing in headphones.
    I tried with several inputs, microphones, amps DI out, mixer signal.
    I also did a unit hard reset to factory settings, but nothing changes.

    Am I missing something?

    Thank you.

    "Music is magic, that's why conductors have the wand" (Ezio Bosso)
  2. #2 by Cecilie Kaasgaard on 1 Week Ago
    Cecilie Kaasgaard's Avatar
    Posts: 95
    Hi Enrico, are you using the AUX input? The two share an input on the board I think so only one can be used at a time. Make sure also to check the monitor input level in the Input section of the Setup.

    Cecilie Kaasgaard
    No longer work in support but I still know a bit about all this stuff!

    Like me? Like my artist facebook-page!
  3. #3 by Enrico Sau on 1 Week Ago
    Enrico Sau's Avatar
    Posts: 41
    Thanks for the reply.
    Yes, Im using auxiliary input.
    I will try to disconnect it and check monitor input.

    "Music is magic, that's why conductors have the wand" (Ezio Bosso)
  4. #4 by Enrico Sau on 1 Week Ago
    Enrico Sau's Avatar
    Posts: 41
    I confirm, the problem is that monitor in, doesn't work if there is anything connected to aux input, like there is only one shared channel and the priority is on aux.
    Very annoying anyway.

    "Music is magic, that's why conductors have the wand" (Ezio Bosso)
  5. #5 by Cecilie Kaasgaard on 1 Week Ago
    Cecilie Kaasgaard's Avatar
    Posts: 95
    Hi Enrico, glad to hear we found the guilty party, and that nothing is broken on your unit. This quirk is actually described in the setup part of the manual, though why it is like this I'm afraid I can't tell you! Hope you find a way to still use both the way you would like to.

    Cecilie Kaasgaard
    No longer work in support but I still know a bit about all this stuff!

    Like me? Like my artist facebook-page!