Question about the Behringer KXD12 / KXD15 keyboard amp DI "Line out" outputs

  1. #1 by Sean Powell on 09-13-2017
    Sean Powell's Avatar
    Posts: 1

    Question about the Behringer KXD12 / KXD15 keyboard amp DI "Line out" outputs

    Regarding the amp's DI "Line Out" outputs (either the XLR or 1/4 TS), if only 1 Line Output is connected, say the Left (L) XLR output, will the signal be summed - so as only mixer 1 channel could be used to DI connect the keyboard amp? For example, say a keyboard is connected to "LINE 2" of the amp using a single 1/4 TS/instrument cable, i.e. using the "LINE 2" L(MONO) input, can the amp be connect to a mixer (e.g. channel 1 of a Behringer XENYX 802 Mixer) using a single Left (L) XLR "Line Out" output or must both L & R XLR "Line Out" outputs be used?
  2. #2 by Michael Lapke on 09-15-2017
    Michael Lapke's Avatar
    Posts: 1,590
    Hi Sean, welcome to the forums!

    To answer your question - yes it does. So if you connect a single mono output from your keyboard to the L (MONO) input of any channel on the KXD15/KXD12, then that signal will be present on the L Line Outputs on the amp. Hope this helps!

    Michael Lapke
    Specialist, Community
    MUSIC Tribe
    BEHRINGER